Installation Instructions; Handle Installation - Danby DUF167A2WDD Guía De Utilización Y Cuidado Para El Propietario

Installation Instructions

LOCATION
1. Select a place with a strong, level fl oor.
2. Allow 5 inches (12.7 cm) of space between the back/sides of the unit and any adjacent wall.
3. Avoid direct sunlight and heat. Direct sunlight could damage the unit. Heat sources nearby will cause higher electricity
consumption.
4. Avoid moist places. Too much moisture in the air will cause frost to form very quickly on the evaporator, and your unit
will have to be defrosted more frequently.
This unit is 76.05 cm (29.94 inches) wide by 170.85 cm (67.26 inches) high by 72.35 cm (28.48 inches) deep, please
make sure that you leave the minimum amount of space between the unit and all surrounding walls and vents (see loca-
tion section). Do not cover any of the ventilation openings with any material as the unit needs adequate space to breathe.
Place the appliance fi rmly on a solid base. Some appliances have adjustable feet on the front side; use them to level the
appliance (some models only).
NOTE: This appliance is intended for FREE-STANDING INSTALLATION ONLY, and is NOT intended to be built-in.
This appliance is approved for INDOOR USE ONLY and is NOT intended for outdoor operation.
Note: Do not operate this unit where the ambient room temperature is below 5°C (41°F)
FEATURES
1. Light Switch
2. Control Panel
3. LED Light
4. Airfl ow Outlet
5. Temperature Sensor
6. Freezer Shelf
7. Airfl ow Inlet
8. Shelf Front
9. Door Shelf
10. Adjustable Feet: Adjust to level your unit.

HANDLE INSTALLATION

For your safety, please unplug the unit before installing the handle:
1. Using two of the provided screws, install them in the predrilled
holes on the unit door, making sure that they have been tightened.
2. Position the handle over the screws.
3. Using the other set of handle screws, install them in the holes on
the side of the handle and turn them until they are fully tightened.
3