Code Identification; Sleep Timer; Code Learning; Tips On Learning - Philips PM725S Manual De Instrucciones

PM725.manual 5/27/08 9:23 AM
Code Indentification

CODE IDENTIFICATION

1. P ress and hold Code Search button until the re d
i nd icator stays on. Release the Code Search button.
2. P ress and release the de s i red mo de button (TV,
VCR, etc.). The red ind icator blinks, then stays lit.
3. Press a release the Code Search button.
The indicator light blinks off.
4. To find the first digit for the code stored under
the mode key pressed in step 2, press each
numeric key from 0-9 in turn. When the indicator
light blinks off the number you pressed is the
first digit for the code you are searching for.
5. To find the second digit, repeat step 4, this
time when the indicator light blinks off this is
the second digit.
6. Repeat step 4 again to find the third digit.
2.
1.,3.
4.
1 2
Page 12

Sleep Timer

The Sleep feature enables the remote to turn off
the TV after a period of 1 to 99 minutes. Remote is
to be in TV mode to set a Sleep Timer. This feature
works even if your TV does not have this feature.
1. Press and release the TV Mode key.
2. Press and hold the Sleep button until LED
remains on (occurring after approx. 2-3 seconds).
3. Release Sleep button.
4. Press and release the numeric keys (01-99) for
the time required. The LED will blink off to
indicate keypress acceptance and remain off after
second keypress.
5. TV Sleep Timer now set.
6. Leave the Remote pointing towards the TV
with an unobstructed path.
To cancel the Sleep Timer, press and hold the Sleep
key until the LED blinks or press and release the
Power key in TV Mode.

Code Learning

TIPS ON LEARNING

1. Use fresh batteries for both the Learning Remote
and the Original Remote.
2. Pe r form a Master clear (see page 15) befo re learning .
3. Place the original remote end-to-end with the
Learning Remote so the IR transmitters on both
remotes are directly in line with each other.
Keep the two remotes approximately one inch
away from each other.
4. Experiment by learning 2 or 3 commands initially
(to ensure compatibility and familiarity) and
then carry out a Master Clear before completely
learning your original remote's commands.
5. Do not try to learn directly under an
incandescent or low-energy light as these can
cause interference with learning. Keep at least
three feet away from any such light sources.
1 3