Blade Sharpening - Worx WG743 Manual De Instrucciones

clog up at the discharge opening. Release
bail handle to turn mower "OFF" and
remove the safety key. Remove the grass
bag and shake the grass down to the back
end of the bag. Also clean out any grass
or debris which may be packed around
the discharge opening. Replace the grass
collection bag.
5. If mower should start to vibrate
abnormally, release bail handle to turn
mower "OFF" and remove safety key.
Check immediately for cause. Vibration
is a warning of trouble. Do not operate
mower until a service check has been
made.
6. ALWAYS RELEASE BAIL HANDLE TO
TURN MOWER "OFF" AND REMOVE
SAFETY KEY WHEN LEAVING IT
UNATTENDED EVEN FOR A SHORT
PERIOD OF TIME.
CUTTING AREA
The cutting area can be affected by several
factors, such as cutting height, lawn humidity,
grass length and density. Besides, starting
and stopping the mower too many times
during operation will reduce the cutting area.
The below table provides the potential cutting
areas based on specific cutting conditions.
Cutting Height
Cutting off 3-1/8''(8cm)
to 2-3/8"(6cm)
* Used with two fully charged battery packs.
TIPS:
1) It is recommended to mow your lawn
more frequently, walk at normal pace,
and not to start/stop the mower too often
during operation. Please always use the
same two batteries and charge the two
batteries at same time.
2) For best performance, please ensure use
a fully charged battery pack and always
Cordless Lawn Mower
Recommend lot
size (maximum)
With 2*20V / 4.0Ah
batteries
up to 5500 sq.ft.
(500m ) *
2
cut off 1/3 or less of the grass height.
3) Walk slowly when cutting long grass,
so as to have more effective cutting and
properly discharge the clippings.
4) Avoid cutting wet grass, otherwise it
will stick to the underside of the deck
and the clippings cannot be collected or
discharged properly.
5) A higher cutting height shall be applied to
new or thick grass and it will extend the
battery duration.
MAINTENANCE
WARNING: Stop the mower and
remove the safety key before
removing the grass bag.
NOTE: To ensure long and reliable service,
perform the following maintenance
procedures regularly. Check for obvious
defects such as a loose, dislodged or a
damaged blade, loose fittings, and worn
or damaged components. Check that the
covers and guards are all undamaged and
are correctly attached to mower. Carry out
any necessary maintenance or repairs before
operating mower. If the mower should
happen to fail despite regular maintenance,
please call our customer helpline for advice.

BLADE SHARPENING

KEEP BLADE SHARP FOR BEST MOWER
PERFORMANCE.
WEAR PROPER EYE PROTECTION WHILE
REMOVING, SHARPENING, AND INSTALLING
BLADE. ENSURE THAT SAFETY KEY IS
REMOVED.
Sharpening the blade twice during a mowing
season is usually sufficient under normal
circumstances. Sand causes the blade to dull
quickly. If your lawn has sandy soil, more
frequent sharpening may be required.
REPLACE BENT OR DAMAGED BLADE
IMMEDIATELY.
WHEN SHARPENING THE BLADE:
1. Make sure blade remains balanced.
2. Sharpen blade at the original cutting angle.
3. Sharpen cutting edges on both ends of
blade, removing equal amounts of material
from both ends.
19
EN