Troubleshooting - Worx WG743 Manual De Instrucciones

NOTE:
1. Be sure the mower is turned off and
remove the key.
2. Place the mower in stand up storage mode.
TO SHARPEN BLADE IN A VISE (SEE Fig.
M1)
1. Be sure the bail handle is released, the
blade has stopped and the safety key
removed before removing the blade.
2. Remove blade from mower. See
instructions for removing and attaching
blade.
3. Secure blade M1-1 in a vise M1-2.
4. Wear safety glasses and be careful not to
cut yourself.
5. Carefully file the cutting edges of the blade
with a fine tooth file M1-3 or sharpening
stone.
6. Check balance of blade. See instructions for
blade balancing.
7. Replace blade on mower and tighten
securely. Refer to instructions below.
BLADE BALANCING (SEE Fig.M2)
Check balance of blade by placing center hole
in blade M2-1 over a nail or screwdriver shank
20
M2-2, clamped horizontally in a vise M2-3. If
either end of the blade rotates downward, file
that end. Blade is properly balanced when
neither end drops.
BLADE MAINTENANCE (SEE FIG. N1, N2)
Renew your metal blade after 50 hours
mowing or 2 years, which ever is the sooner-
regardless of condition.
TROUBLE SHOOTING
Problem
1. Mower doesn't run
when bail handle is
activated.
Cordless Lawn Mower
A. Check to make sure safety key has been installed and is fully
seated and that button on switch housing is being completely
pushed.
B. Release Bail handle to turn mower off. Remove safety key, turn
mower over and check that blade is free to turn. If not free, return
to an authorized servicer. Blade should turn freely.
C. Has battery been fully charged? Plug in charger and wait for
green light to come on.
Follow these procedures to remove and
replace the blade. You will need garden gloves
(not provided) and a spanner wrench (not
provided) to remove the blade. Hold the blade
(19) and unscrew the blade bolt (18) counter-
clockwise using a spanner wrench, and then
remove blade.
To re-assemble, position the blade (19) with
the cutting edges towards the ground. Then
securely tighten the blade bolt (18).
STORAGE (SEE Fig. L1, L2)
Stop the mower and always remove the
safety key. Clean the exterior of the machine
thoroughly using a soft brush and cloth. Do
not use water, solvents or polishes. Remove
all grass and debris, especially from the
ventilation slots.
Turn the machine on its side and clean the
blade area. If grass cuttings are compacted
in the blade area, remove with a wooden or
plastic implement.
Store the machine in a dry place. Do not place
other objects on top of the machine.
To aid storage, release the Lock Cam Lever,
and fold the upper handle as shown in Fig. L1,
L2.
For Battery tools
The ambient temperature range for the use
and storage of tool and battery is 0°C-45°C
(32°F-113°F).
The recommended ambient temperature
range for the charging system during charging
is 0°C-40°C (32°F-104°F).
Solution
EN