GE JD630SFSS Instrucciones De Instalación página 4

3 ­ W HEN INSTALLING RANGE IN COUNTERTOP CUT OUT TO THE WALL
If­the­counter­opening­extends­to­the­walls,­it­will­require­maintop­filler­kit­(JXS66XX)­or­back-guard­kit­(JXS36XX,­
JXS39SS,­or­JXS32XX)­to­close­the­gap.­Refer­to­the­filler­or­back­guard­kit­instructions­for­installation­details.
NOTE:­If­the­countertop­is­greater­than­25"­it­will­show­a­gap­between­the­back-guard­and­wall­or­between­
filler­kit­and­the­wall.
25"
10-3/8" from
countertop to
anti-tip support
29-15/16" Min.
30-1/16" Max.
4 ­ P REPARING THE RANGE
Remove Oven Door
Door­removal­is­not­a­requirement­for­installation­of­
the­product­but­is­an­added­convenience.­To­remove­
the­door:
1.­­­ O pen­the­oven­door­as­far­as­it­will­go.
2.­­­ P ush­both­hinge­locks­toward­the­door­frame­
to­the­unlocked­position.­This­may­require­a­flat­
blade­screwdriver.
Hinge
Slot
Hinge Arm
NOTE: The oven door is very heavy. Be sure you have a firm grip before lifting the oven off the hinges.
Use caution once the door is removed. Do not lay door on its handle. This could cause dents or
scratches.
Installation­Instructions
Must be Flat
Wall
9/16"
Must be Flat
Hinge Lock
(Unlocked
Position)
9/16"
An­additional­anti-tip­bracket­
support­must­be­mounted­to­
the­rear­wall­of­the­cutout.­
The­anti-tip­bracket­support­
is­typically­a­2x4­piece­of­
lumber­screwed­directly­into­
Anti-Tip Support
the­wall­studs.­The­anti-tip­
bracket­support­must­be­able­
to­withstand­200­lbs­of­force­
at­the­engagement­point.
3.­­­ P lace­hands­on­both­sides­of­the­
door,­and­close­the­door­to­the­
removal­position.­This­is­half­way­
between­the­broil­stop­and­fully­
closed.
4.­­­ L ift­the­door­up­and­out­until­the­
hinge­arms­clear­the­slots.
Hinge­
Clears­Slot
4
WARNING
­