8 - REPLAcEMENT OF THE SPRING
A
D
G
The spring wich allows to rewind the hose is placed inside a proper housing centre wich is joint to the drum.
WARMING !
THE DISASSEMBLy OF THE SPRING IS ONLy PERMITTED TO SUITABLy TRAINED
STAFF. HANDLE WITH THE GREATEST cARE SPRING TO AvOID SERIOUS
AccIDENTS (FIGURE A).
1.
Make sure that the rewinding system is totally unloaded and that the drum is free (See
point 1 chapiter 7).
2.
Loosen the swivel joint (Figure B).
3.
Loosen the 2 screws on the spring side by a 10 mm wrench (See point 3 chapiter 7).
4.
Disassemble the opening on the spring side by a 10 mm wrench and take out the drum (Figure C).
5.
Take out the shaft from the spring housing (Figure D).
6.
Lift the tangs on the drum by a screwdriver and rotate the spring housing centre in order to
release it from the drum (Figure E).
7.
Turn upside down the drum and take out the spring housing centre paying the greatest
care so that the spring does not go out of it (Figures F and G).
8.
Insert and hook the shaft into the new spring housing centre.
Lubricate the spring and the shaft.
9.
Put the drum straight and place the new spring housing centre with the utmost care.
Block the tangs (Figure H).
10.
Assemble all the parts and go on as indicated at point 2 of the chapter 6 "Mouting the hose".
B
E
H
14
c
F