Configuration - Modine ECO KCE Serie Manual Tecnico

KCE ventola Ø 800 - Ø 910 - Ø 1000 mm
Installation of single row motor models
Configuration H
1
Secure model to lifting points and
lift it.
Configuration V
1
Hook model to lifting brackets
and rotate it.
3
1 2
3
Fasten support legs supplied with
model (1-2-3).
IMPORTANT:
In lifting and handling operations use all lifting points indicated on model, if necessary use a beam in order to evenly dis-
tribute the suspended load.
In some cases the assembly of the support legs/brackets is carried out beneath the suspended model, therefore it is es-
sential to take all the necessary measures required to ensure the safety of the operators. It is recommended to prepare
a scaffold sturdy enough to place the model on during such operations.
Should the support legs/brackets be removed the screws must be fastened anyway.
It is advisable to store the removed support legs/bracket for future handling of unit.
During transfer and handling care must be taken in order to prevent damage to the refrigerant inlet/outlet headers.
2
Transfer model to installation site,
fasten it with adequate fastening
screws and peel off the protective
plastic film from casing.
2
Secure model to lifting points and
lift.
4
Transfer model to installation site,
fasten it with adequate fastening
screws and peel off the protective
plastic film from casing.
Installation of two-row motor models
Configuration H
1
Hook model to lifting points and
lift it.
Configuration V
1
Hook model to lifting points and
lift it.
3
Reposition lifting point as illustra-
ted.
5
Transfer model to installation site,
secure it with adequate screws and
remove the brackets that were used
for hauling.
2
Transfer model to installation site,
secure it with appropriate screws,
brace by fastening ropes to the upper
lifting brackets, remove the brackets
used for moving the unit and peel off
protective film from casing.
2
Place the model against an inclined
base and position the unit in order
to obtain the desired configuration.
4
1
2
3
Fasten the model to the new brackets,
lift it and e mount the support legs
supplied loose with unit. (1-2-3).
6
Remove immediately protective film
from casing.
43
www.modine.com