Reference Standards And Laws; Handling; Unpacking; Positioning - KBS C74GD Instrucciones Para Instalación, Uso Y Mantenimiento

• Identify the specific appliance model. The
model number is detailed on the packa-
ging and on the appliance data plate.
• The appliance must be installed in a well-
ventilated room.
• Do not obstruct any air vents or drains pre-
sent on the appliance.
• Do not tamper with appliance components.

6 REFERENCE STANDARDS AND LAWS

Install the appliance in compliance with cur-
rent safety regulations.
Install the appliance in compliance with cur-
rent regulations.

7 HANDLING

The packaging is marked with warning
symbols that indicate the precautions to
be taken when handling the appliance to
avoid damage.The appliance must only be
handledusing suitable equipment. If lifting
equipment is used, such as forklift trucks or
similar, make sure that the appliance is in a
stable position.

8 UNPACKING

Check the state of the packaging and in the
event of damage, ask the delivery person to
inspect the goods.
• Remove the packaging.
• Remove the protective film from the exte-
rior and interior panels. Use a suitable sol-
vent to remove any residual adhesive from
the panels.

9 POSITIONING

• The overall dimensions of the appliance
and the position of connections are given
on the installation diagram at the start of
this manual.
10

FUMES EXHAUST SYSTEM

Provide a fumes exhaust system based on
the "Type" of appliance.The "Type" is stated
on the appliance dataplate.
6
APPLIANCE TYPE "A1"
• Position the "A1" type appliance below an
extractor hood to ensure smoke and fu-
mes generated by cooking are removed.
APPLIANCE TYPE "B21"
• Position the "B21" type appliance below
an extractor hood.
APPLIANCE TYPE "B11"
• Fit the "B11" type appliance with a suitable
flue, available from the appliance manu-
facturer. Follow the assembly instructions
provided with the flue.
• Connect the flue to a 150/155 mm diame-
ter hose, heat resistant to 300°C.
• Vent to the outside or into an efficient flue.
The hose length must not exceed 3 me-
tres.

11 CONNECTIONS

The position and dimensions of connec-
tions are given in the installation diagram at
the start of this manual.
CONNECTION TO THE GAS SUPPLY
Check the compatibility of the gas supply.
Check the details given on the decals on
the packing and on the appliance. If neces-
sary, convert the appliance to the type of
gas utilized. Follow the instructions in the
next paragraph "Conversion to a different
type of gas".
On top appliances a rear connection is also
available. Remove the plug present and
screw it tightly onto the front connector.
• A rapid-action gas shut-off valve must be
fitted upstream of the appliance in an ea-
sily accessible position.
• Do not use connection pipes having a dia-
meter smaller than that of the appliance's
gas connector.
• Once the appliance has been installed,
check for leaks at the connection points.