Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4. Plug the solar panel cable into the side of the
sensor housing. Note: Allow extra cable to hang
below the sensor housing for water to drip off
cable (drip loop).
IMPORTANT: Allow the batteries to charge
with two days of sunshine before testing.
Wall mount
Drip Loop
Forming a Drip Loop in the Solar Panel Cable
5. Install 3 Ni-Cd rechargeable AA batteries
(included) into battery compartment according
to markings. Note: Rechargeable batteries will
eventually lose their ability to hold a charge.
When this happens, replace with Ni-Cd or
Ni-MH rechargeable AA batteries available
at most stores.
nOtice: When replacing rechargeable batter-
ies, recycle used batteries or dispose of them
in accordance with local regulations.
RANGE
MIN
MAX
OFF
TEST
1 MIN
5 MIN
ON-TIME
Install Batteries in Battery Compartment
598-1316-05
eave mount
AA SIZE
AA SIZE
AA SIZE
RECHARGEABLE
ONLY
6. To adjust light direction, loosen lock nut and
rotate light to desired position. Tighten lock
nut.
Lock Nut
Turning Lock Nut
test anD aDJustment
Note: Sensor has a 30 second warm up period
before it will detect motion. When switching
modes wait 30 seconds.
1. Slide the sensor switch to the TEST position.
2. Place the RANGE adjustment in the medium
position (halfway between MIN and MAX
position).
RANGE
MIN
MAX
OFF
TEST
1 MIN
5 MIN
ON-TIME
Controls in Battery Compartment
3
AA SIZE
RANGE
AA SIZE
AA SIZE
AA SIZE
MIN
MAX
OFF
TEST
AA SIZE
AA SIZE
RECHARGEABLE
1 MIN
ONLY
5 MIN
ON-TIME
RECHARGEABLE
ONLY
Tabla de contenido
