TOYAMA TDWG12000CXE-N Guia Del Propietario página 9

The engine oil decreases slowly when unit is running continuously. In order to
avoid lacking of engine oil to cause fault , inspect the oil level and add engine
oil if necessary.
2) Check the cooling water in radiator.
Radiator
Be careful of the hot radiator. It's very dangerous to open the radiator cover when the
cooling water is very hot. The vapor and splashed water may scald you seriously.
Don't open the radiator cover when the engine is running or after the engine is stopped just
for a while. Because the cooling water temperature is very high in this time.
Check the cooling water after the engine stops.
Open the radiator cover when check it, check the radiator if full of the cooling water or not.
Tighten the radiator cover by turn it in right after checking. Otherwise, the cooling
water may be vaporized, causing a fatal fault.
3) Check the fan belt
Check the tension and the extend length of the belt. Check the belt if good or not.
Replace it if necessary. Refer to its engine manual for the regulation or replacement of the belt.
4) Check the fuel
Check the fuel level if normal before running the generator. Often open the drain plug in the fuel
tank to drain the sediment and impurity.
5) Check the grounding protection
The generator frame and load generator frame must be installed grounding protection, and make
sure the grounding protection is ok.
6) Check the water leakage and oil leakage.
Inspect the wholly unit and open the door to check if there is water leakage and oil leakage. If there
is, please contact with your dealer for service.
7) Check the looseness of the parts.
Check the nuts and screws if loosened. If loosened, tighten them. Specially inspect the air cleaner,
muffler, and charging alternator.
Pay attention to the broken cables and loosened terminals.
9