Battery Backup Assembly Instructions - LAZBOY PowerReclineXR Instrucciones De Operación

Ocultar thumbs Ver también para PowerReclineXR:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

PowerReclineXR
Rocking Loveseat Assembly Instructions
NOTICE:
– To reduce the risk of product damage:
• Do not move the units while connected together. The purpose of the bracket system is to
connect the units and prevent them from being separated while on the floor. The bracket
system does not provide adequate structural support for the movement of connected units.
8. The units must be disconnected before moving the loveseat. To disconnect the units, lift up the left front
corner of the right side (sitting) recliner approximately 3" to clear the front attachment bracket on the
console. Move the recliner to the side before returning it to the floor. Slide the right side (sitting) recliner
backward to disengage the back bracket on the console. Repeat these steps to disconnect the console
from the left side (sitting) recliner.
9. Proceed to the Battery Backup Assembly Instructions.
F
1
IGURE
Left Side (Sitting) Rocker Recliner
Rear Bracket
Front Attachment
Bracket
F
3
IGURE
Console
Rear
Side
Mount
Bracket
Front Side
Mount "U"
Bracket
12
®
F
2
IGURE
Right Side (Sitting) Rocker Recliner
Threaded
Studs
F
4
IGURE
Front Attachment
Bracket (Left Side
Sitting Rocker
Recliner)
Front Attachment
Bracket (Console)

Battery Backup Assembly Instructions

Replace the power transformer batteries every six months and
NOTICE:
after each power failure use. Under normal conditions, the battery
backup will operate the chair two times, but this performance
cannot be guaranteed.
The performance of the built-in battery backup cannot be guaranteed. If you require continuing
use during a power outage, you should purchase a separate battery backup system. Contact
your La-Z-Boy
®
dealer for more information.
To reduce battery consumption, the massage and heat features are blocked and unavailable
when the battery backup is in use. Additionally, the operating speed is reduced to decrease
energy consumption.
Always maintain constant even pressure on the button when operating on battery backup to
reduce the energy consumption.
The battery backup is located in the power transformer and uses two good quality, name brand
9-volt alkaline batteries (not included).
1. Unplug the 120 volt power cord from the electrical outlet, and disconnect the power
transformer connector from the power supply connector.
2. The battery compartment is located in the bottom of the power transformer. Slide the battery
cover over to access the battery compartment.
3. Snap the connection caps on the battery terminals. Place the batteries in the power transformer.
4. Slide the battery cover over the batteries.
5. Proceed to the Operating Instructions.
Power
(2) 9-Volt
Transformer
Alkaline Batteries
PowerReclineXR Transformer Specifications:
Input: 100V-240V~, AC 50/60Hz, 1.5A
Output: 29V, DC 2A
Battery
Cover
13
Tabla de contenido
loading

Tabla de contenido