Wiring; Canopy Assembly - Litex WOD52ABZ5 Manual Del Usuario

7. Wiring.

CAUTION: Be sure outlet box is properly grounded or
that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National Electrical
Code. If you are unfamiliar with electrical wiring or if
the house/building wires are different colors than
those referred to below, please use a qualified
electrician.
Note: Excess lead wire length from the fan can be cut
to the desired length and then stripped.
WARNING: If using this fan in a WET or DAMP
location, this fan must be connected to a supply
circuit that is protected by a Ground Fault Circuit
Interrupter (GFCI) to reduce the risk of personal
injury, electrical shock or death.
When downrod is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect BLACK wire from fan to BLACK wire from
ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire from
ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together from
fan to BARE/GREEN wire from ceiling with wire
connector provided.
Since this fan does not come with a light kit, you
will need to cap off the BLUE wire with a wire
connector (as shown with arrow in diagram at right).
[Note: If you elect to purchase a light kit for the fan,
the BLUE wire from the fan must be connected to
the BLACK wire from the ceiling instead.]
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
This fan is remote control adaptable (remote control
sold separately). Note: Only remote controls
approved for WET locations can be used with this fan.

8. Canopy Assembly.

Temporarily raise canopy to hanging bracket to
determine which screws in hanging bracket align
with slotted holes in canopy, and then lower
canopy and partially loosen these 2 screws.
Remove the other 2 screws and set aside.
Now, lift canopy to hanging bracket again,
aligning slotted holes in canopy with loosened
screws in hanging bracket. Twist canopy to lock.
Re-insert the other 2 screws and secure all screws
with Phillips screwdriver.
white supply wire
black supply wire
from ceiling
black
white
white
black
blue
from fan
page 6
ground
(green or bare)
ground
(green
or bare)
*
hanging bracket
canopy