Litex WOD52ABZ5 Manual Del Usuario página 5

5. Fan Assembly (with downrod).
If you wish to extend the hanging length of your
fan, you must remove the hanging ball from the
4in. downrod provided to use with an extended
downrod (sold separately). [If you wish to use the
4in. downrod, please proceed to instructions
following the dotted line below.]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove stop
pin. Slide hanging ball off the original downrod, A,
and slide it down the longer downrod, B (the top
of the downrod should be noted as having a set
screw hole; use this hole when setting the set
screw). Insert stop pin into top of extended
downrod and raise hanging ball. Be sure stop pin
aligns with slots on the inside of the hanging ball.
Tighten set screw securely.
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
Loosen yoke set screws and nuts in motor
housing yoke and remove pin and clip from
motor housing yoke. Slide downrod through
canopy and weatherproof yoke cover.
Thread safety cable and electrical wires through
downrod and pull extra wire slack from the upper
end of the downrod.
Place downrod into the motor housing yoke and
re-insert pin and clip that were previously
removed. Tighten yoke set screws and nuts
securely. Lower weatherproof yoke cover to
motor housing.
Remove electrical tape from electrical wires and
thread one wire through each hole in the
weatherproof hanging ball cover. Pull
weatherproof hanging ball cover down securely
over hanging ball (on downrod).
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common
sense and caution are necessary factors in the
installation and operation of this fan.
set screw
A
electrical wiring
hanging
ball
weatherproof
yoke cover
clip
page 4
set screw hole
stop pin
hanging ball
B
weatherproof
hanging ball cover
downrod
canopy
yoke set screw
pin
motor
housing