Fan Assembly. Pgs - Litex WOD52ABZ5 Manual Del Usuario

5. Fan Assembly (with downrod). (cont.)
With the hanging bracket secured to the outlet
box and able to support the fan, you are now
ready to hang your fan. Grab the fan firmly with
two hands. Slide downrod through opening in
hanging bracket and let hanging ball rest on
the hanging bracket. Turn the hanging ball slot
until it lines up with the hanging bracket tab.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you
once you are set on the ladder.
Continue to "Wiring" section for wiring diagram.
6. Fan Assembly (flushmount).
Remove and set aside canopy cover to reveal 6
holes. Notice that 3 of these holes are larger
than the others.
Note: Weatherproof yoke cover is not used with
this type of installation.
If there are only 3 screws in top of motor
housing, please proceed to next paragraph. If
there are 6 screws in top of motor housing,
remove every other screw and lock washer.
Remove pin, clip and set screws from motor
housing yoke. Thread wiring through canopy.
Place canopy over yoke, aligning larger holes in
canopy with the 3 existing screws in top of
motor housing. Insert the 3 screws and 3 lock
washers that were removed (if there were only 3
screws located in top of motor housing, these
screws/lock washers will be located in one of
the hardware packs) into the remaining holes.
Securely tighten these screws.
To prepare the fan for wiring, hang fan onto
hanging bracket by sliding the canopy over the
hanging bracket tab. (Use one of the
non-slotted holes on the rim of the canopy to
do so.)
set screw
clip
canopy
page 5
hanging bracket tab
hanging ball slot
canopy
canopy cover
canopy
motor housing
hanging
bracket tab
motor housing
pin
yoke