Tabla de contenido
Idiomas disponibles
Idiomas disponibles
FUNCTIONAL
DESCRIPTION
Figure A
1. Variable speed switch
2. Lock-on button
3. Variable speed control knob
4. Forward/Reverse slider
5. Drilling mode selector
6. Keyed chuck
7. Depth stop rod
8. Side handle
ASSEMBLY
injury, before assembly, make sure that the
WARNING:
tool is switched off and unplugged.
ATTACHING THE SIDE HANDLE -
(FIGURE B)
The drill is equipped with a side handle, and
must be installed properly to control the drill.
• Turn the grip counterclockwise until you
can slide the side handle (8) onto the front
of the tool as shown.
• Rotate the side handle into the desired position.
• Insert the depth stop (7) into the mounting
hole as shown.
• Set the drilling depth as described under "Setting the Drilling Depth".
• Tighten the side handle by turning the grip clockwise. Make sure that the side handle is
secure and does not slip.
INSERTING A DRILL BIT OR OTHER
ACCESSORY (FIGURE C)
WARNING:
tighten drill bits (or any other accessory)
and turning the tool on. Damage to the
by gripping the front part of the chuck
chuck and personal injury may occur when
changing accessories.
is secure before starting the tool. A
WARNING:
loose bit may eject from tool causing
possible personal injury.
• Open the chuck (6) by turning the collar
counterclockwise (when viewed from the
chuck end).
• Insert the accessory shaft (10) into the chuck to
about 3/4 in. (19 mm) depth, centered in the
jaws.
A
To reduce the risk of
Do not attempt to
Always ensure the bit
B
C
5
Tabla de contenido
