Powerreclinexrw ™ Motion Sofa; Assembly Instructions - LAZBOY PowerRecline XR Instrucciones De Operación

PowerReclineXRw

Assembly Instructions

NOTICE:
Do not plug in until instructed.
1. Starting with all packaging removed from the unit, locate the boxed power transformer, packaged
120 volt power cord and bubble wrapped optional hand wand (if applicable) secured to the body
bracket of the unit (F 1); there is one each per reclining seat.
IGURE
2. Carefully cut the plastic tie(s) securing the parts. Unpack the power transformers and 120 volt
power cords and set aside. For units with optional hand wands, remove the bubble wrap and
place the hand wand on the seat (F
IGURE
WARNING
– To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
3. Install the back.
Lay the backs face down on the seats. Starting with one back, turn the locking levers, located
•
on the brackets attached to the back (one on each side), 45 to 30 degrees from vertical (F
Hold the back at a slight angle to the seat and align the brackets on the back with the brackets
•
on the body (F 4).
IGURE
Rotate the back upright and lower the back onto the body (F
•
body brackets are completely engaged.
To make sure the back is properly installed with both sets of back and body brackets
-
engaged, stand behind the unit and twist the back from side to side. If one or both sides
move out of position the brackets are not engaged (F
repeat the steps above.
If you are unable to install the back properly, contact your La-Z-Boy
-
Lock both back brackets by using a screwdriver to push the locking levers down (F
•
Repeat this step for each back.
•
(Assembly Instructions Continued)
14
™ Motion Sofa
2).
4), making sure the back and
IGURE
5). Remove the back and
IGURE
® dealer for assistance.
IGURE
F 1
IGURE
Hand Plastic
Wand Tie
3).
IGURE
F 3
IGURE
Back
Bracket
6).
F 5
IGURE
Back and body brackets on this side are not
engaged. Remove the back and reinstall.
PowerReclineXRw ™ Motion Sofa
Assembly Instructions
F
IGURE
Power Transformer & Hand
120 Volt Power Cord Wand
F
IGURE
45 Degrees
from
Vertical
Locking
Lever
Body Bracket
Back Bracket
F
IGURE
Back
Bracket
2
4
6
Locking
Lever
at 45
Degrees
from
Vertical
Locked
Position
15