Installation Steps - LUND 26510020 Instrucciones De Instalación

Installation Steps

Beginning on the passenger side, remove plastic plugs or factory
hex bolts (if equipped). (Figure 1)
1
Repeat Step 2 for Center and Rear Mounting Bracket installation, (Figures 3 & 4).
3
Align the passenger side nerf bar with the passenger
side front mounting bracket and loosely attach using (2)
8mm bolts, (2) 8mm lock washers, and (2) 8mm flat
washers. Do not fully tighten at this time.(Figure 5)
4
NOTE: Actual application may vary slightly from illustrations.
Figure 1
Figure 3
Figure 5
Partially attach passenger side Front Mounting
Bracket to the vehicle using (2) 8mm Hex Bolts, (2)
8mm Lock Washers and (2) 8mm Flat Washers. Do
2
Repeat Step 4 to attach the nerf bar at the middle and
5
Page 2 of 3
not fully tighten at this time. (Figure 2)
Figure 2
Figure 4
rear bracket locations. (Figure 6)
Figure 6