Glacier bay LT2036WWHD Instrucciones De Ensamble E Instalación página 6

1. Basket Strainer installation
Unscrew nut (20-F) and remove T-washer (20-E) from strainer body (20-A). NOTE: T-washer and nut will be used in step 9.
Disassemble strainer body (20-A), by unscrewing the large locknut (20-D) and removing the paper washer (20-C) and the
rubber washer (20-B).
Apply a sufficient amount of plumbers putty (not included) between the strainer and sink basin (A). Insert strainer body (20-A)
through the drain hole in the sink basin (A). Holding strainer body firmly in place, position rubber washer (20-B) then the paper
washer (20-C) onto the strainer body under the sink basin (A).
Screw lock nut (20-D) onto the threaded shank of the strainer body (20-A) and tighten, DO NOT OVERTIGHTEN!
Remove any excess plumbers putty from strainer body (20-A) and sink basin (A).
20-A
plumbers putty (not included)
A
20-B
20-C
20-D
20-E
Unscrew nut.
T-washer and nut will be
used in step 9.
20-F
www.HOMEDEPOT.com IS2038
Pg 6 of 34