Tabla de contenido
Idiomas disponibles
Idiomas disponibles
•
Determine the length of plastic
tubing that will be necessary to connect
the system head outlet to the
refrigerator. Make sure to allow enough
plastic tubing to prevent kinking in the
line and that you can pull the
refrigerator out from the wall 6' - 8'.
•
Cut the plastic tubing squarely on
both ends, making sure not to crimp the
plastic tubing during cutting.
•
Wet end of the inlet plastic tubing with
water and push it into the inlet port
until it stops.
•
Wet end of outlet plastic tubing and
insert into the outlet port.
•
Cut end of outlet tubing 1 ½" from
outlet port.
•
Attach Flow Controller to outlet tubing
1 ½" from System Head. Note flow
direction arrows on Flow Controller.
•
Attach remaining outlet tubing into
outlet port of Flow Controller.
RFS-301 installation instructions
Attach tubing/fittings
Step 3
to the water line/head
materials and tools needed
utility knife
wet ends of tubing before inserting
cut squarely on both ends
do not bend or crimp
do not cut at an angle
PLASTIC TUBING
CONTROLLER
SYSTEM HEAD
SYSTEM HEAD
PLASTIC TUBING
FLOW
7
Version 1.0D
Tabla de contenido
