Reference Standards And Laws; Unpacking; Positioning; Alignment Of The Trolley Rack - LIBRETTO EM E6/11-D Instalación, Uso, Mantenimiento

technicians authorized by the manufacturer, in compliance with current safety standards and the
instructions in this manual.
Do not obstruct any air vents or drains present on the appliance.
Do not tamper with appliance components.

4. REFERENCE STANDARDS AND LAWS

Install the appliance in accordance with the safety standards in force in the country.

5. UNPACKING

Check the state of the packing and in the event of damage, ask the delivery person to inspect the goods.
Remove the packing.
Remove the protective film from the outer panels. Use a suitable solvent to remove any residual
adhesive from the panels.

6. POSITIONING

THE MANUFACTURER WILL NOT BE LIABLE FOR ANY DAMAGE OR INJURY RESULTING
FROM FAILURE TO OBSERVING THE FOLLOWING RULES.
Identify the specific appliance model. The model number is detailed on the packing and on the
appliance dataplate.
The appliance must be installed in a well-ventilated room.
Do not obstruct any air vents or drains present on the appliance.
Do not tamper with appliance components.
The overall dimensions of the appliance and the position of connections are given on the installation
diagram at the end of this manual.
Place the appliance at proper distances from other devices or from the walls. They must be sufficient to
allow accessibility to the technical service. These distances are detected by the installation diagram
corresponding to the oven to be connected.
The appliance is not suitable for integrated installation.
If the appliance is to be be placed near walls, dividers, kitchen furniture, decorative elements etc. this
must be made of non-combustible materials
Otherwise, they must be covered with suitable non-combustible heat insulating materials.
Level the appliance by means of the height-adjustable feet
For the floor models the appliance must be put to bubble: slight unevenness of the supporting surface
can be eliminated by adjusting feet (screwing or unscrewing).
Significant height differences or inclinations may adversely affect the functioning of the oven.
For models equipped with trolley rack you need to take extra care in leveling.

ALIGNMENT OF THE TROLLEY RACK

In case the floor is not flat, you need to overcome the defect with a ramp with a maximum gradient of
4 ° (not included in the supply).
If there is a drain grate in front of the equipment, you must apply lanes in the entry area of the trolley
rack.
21