Handle Assembly - sunjoe 24V-X2-21LM Manual Del Operador

Fig. 4
m
CAUTION!
FIRE HAZARD. When removing the batteries
from the charger, be sure to unplug the charger from the outlet
first, then remove the batteries from the charger.
m
WARNING!
This charger does not automatically turn
off when the batteries are fully charged. Please take care not
to leave the batteries in the charger. Switch off or unplug the
charger at the mains when charging is complete.
7. Timely recharging of the batteries will help prolong the
batteries' life. You must recharge the battery packs when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery packs to become
fully discharged as this will cause irreversible damage to the
batteries.
Charging a Hot or Cold Battery Pack
The green indicator lights on the charger base indicates that
the battery packs' temperatures are outside the charging
range. Once the packs are within the acceptable range,
normal charging will take place and the red light will be
continuous. Hot or cold battery packs may take longer to
charge.
Lithium-Ion Charging Status
Charger
Battery
Base
Pack
Indicator
Temperature
Light
Too hot
Green
Normal range
Red
Too cold
Green
Push lock
button
Battery
Pack Charging
Indicator Status
Light
Flashing
Not charging
together
Flashing Normal
one by one charging
Flashing
Not charging
together
Assembly
m
WARNING!
Do not insert the batteries until assembly is
complete. Failure to comply could result in accidental starting
and serious personal injury.
m
WARNING!
Before performing any maintenance,
make sure the batteries and the safety key are removed from
the unit. Failure to heed this warning could result in serious
personal injury.
m
WARNING!
The product must be fully assembled
before operation. Do not use a product that is only partially
assembled or assembled with damaged parts.
NOTE: Before using the mower, follow these instructions to
assemble the handle and grass bag.

Handle Assembly

1. The unit arrives with the lower handle frame in the storage
position and the upper handle detached. Lift the lower
handle to the desired height and tighten the preassembled
knobs (Fig. 5).
2. Fit the upper handle frame onto the lower handle. Insert
the provided latches into the washers and the aligned
holes on the handles and secure the latches on the handle
frame (Fig. 6).
10
Lower handle Fig. 5
frame
Tighten the knobs