Atos PROVOX TruTone EMOTE Instrucciones De Uso página 4

• Test the device, listening to the tonal qualities. If you prefer the tonal qualities
without the spacer, be sure to store the Spacer in a safe place, such as the box your
device came with.
6. Setting the MODE:
The MODE Button is inside, under battery cap; the arrow on the battery points towards
the button. (NO TOOLS!)
NOTE: For users with a Legacy TruTone
the red Range adjustment.
This device has six modes. To change the mode, press both the Mode button and the
Power button. (The timing is not critical.) The MODE changes immediately, but if you
continue to hold the Power button, the device will beep to indicate the new MODE
setting. The number of beeps and the tone of the beeps indicate which mode it is in.
MODES 1-4: Are like the original TruTone
#1 is monotone, and Modes 2 through 4 have increasing range on the button. Beep
count indicates mode.
Mode 1 – Monotone
Mode 2 – Low tonal variations
Mode 3 – Medium tonal variations
Mode 4 – High tonal variations—2-octave range.
MODES #5-6: Volume Mode, lets you control the volume with the Power button,
instead of the tone. This is for people who do not use the tone control, and allows
volume control without moving the knob. A very light touch let's you speak with your
„whisper voice," while pressing firmly emits sound at full volume. The volume control
knob still limits your max volume. Changing into these modes creates a „Whoop"
sound (with an increasing tone), rather than a steady tone beep.
Mode 5 – Low Sensitivity—full volume requires more pressure. 2 „Whoops"
Mode 6 – High Sensitivity—full volume requires less pressure. 3 „Whoops"
7. Batteries & Charging
1. Use only approved Li-Ion Batteries.
2. Install Battery (F) as shown; it only fits one way. The Battery Connector (H)
alignment tab points up, with the red wire to
the right.
3. Use until volume begins to fade, which is at 80% drained. You will still have up to
another week or more of battery life (depending on your talk time), and battery life
will be extended by the volume reduction.
7a. Indicator Light, Battery Low:
The LED light turns on if the battery is 80% drained (or more) when you press the
Power button to let you know it is fully functioning, but approaching time to charge.
7b. Charging
• You may charge on a schedule, proactively; i.e. once a week, or once every two
weeks.
• To charge, pull the USB Dust Cover (U) out at the top end, revealing the USB
Charge Jack (V).
• Plug in a Micro-USB Cord into the USB Charge Jack (V).
• Charger Specifications: 5v, 750mA minimum (or .75A minimum).
7c. Indicator Light, Charging:
• When charging, the LED indicator light turns on solid.
• When charging is complete, the LED indicator light flashes.
• Unplug the unit when the charging is complete to conserve power.
4
electrolarynx, the MODE button replaces
®
electrolarynx, with four preset Ranges.
®
1 Beep
2 Beeps
3 Beeps
4 Beeps