Charging The Battery - brennenstuhl BS 8050 MH Manual De Instrucciones

Operating instructions
3a
≤1 s
OPERATION OF THE HYBRID FLOODLIGHT WITH POWER SUPPLY
The floodlight can be connected to the power supply using the supplied plug-in cable via
the connection socket at the back side (fig. 4).
To switch the floodlight on, operate the button on the back (fig. 3).
Press the button multiple times (fig. 3a), to set the brightness to 100%, then 50% and then
"off". Keep the button pressed (fig. 3b) to continuously reduce or increase the brightness.
If the switch is left in any of its "on" positions for longer than 5 seconds, then pressing it
once again will always turn it off.
If the floodlight is connected to the mains, the battery is not charged.
If the floodlight is connected to the power supply, the floodlight is operated with mains
voltage by default. In case of power failure or if the device is unplugged from the mains, the
floodlight will automatically switch to battery operation if a battery with sufficient charging
is inserted into the battery holder. This is signalled by the floodlight flashing five times.
4

CHARGING THE BATTERY

Only use an original Bosch charging device.
TRIPOD MOUNTING
By means of the holes in the holding bracket, the floodlight can be mounted on a
Brennenstuhl tripod; fastening screws are included in the scope of delivery.
10
004521 BA_BS 8050 MH_BS 8052 MH 0533060.indd 10 004521 BA_BS 8050 MH_BS 8052 MH 0533060.indd 10
3b
≥1 s
100%
50%
BS 8050 MH / BS 8052 MH
100%
10%
31.05.21 13:24 31.05.21 13:24