Removing The Unit - Medion MD 80907 Instrucciones De Manejo

Installation
Arrangement of the ISO block
Problems due to incorrect cable connections
In some vehicle models, the standard arrangement of the cables [4] and [7] in
the ISO block A (see above) is exchanged at the factory.
If this is the case in your vehicle, certain functions may be impaired: stations may
not be stored properly, for example.
To solve this, the red cable (switched plus) and the pink cable (permanent plus)
will need to be reversed in the ISO block.

Removing the unit

To remove the unit, first remove the
blind frame and introduce the left and
right key into the corresponding slit on
the side of the unit. The flaps will be bent
back and you can remove the unit.
GB-10
BLOCK B – Speakers
1 rear right +
2 rear right
3 front right +
4 front right
5 front left +
6 front left
7 rear left+
8 rear left
BLOCK A – Electricity supply
1
2
3
4 Switched plus (permanent
12V supply from main
electrical system)
5 Car antenna (also for
external amplifiers, etc.)
6
7 Alternating plus (alternating
12V voltage, via ignition)
8 Earth