Black and Decker MOUSE MS800 Manual De Instrucciones página 4

• ANSI Z87.1 eye protection (CAN/CSA Z94.3)
• ANSI S12.6 (S3.19) hearing protection
• NIOSH/OSHA/MSHA respiratory protection
• Sanding of lead-based paint is not recommended. See Sanding Lead Based Paint for
additional information before sanding paint.
• Clean your tool out periodically.
When using an extension cord, be sure to use one heavy enough to carry the current your
Extension Cords
product will draw. An undersized cord will cause a drop in line voltage resulting in loss of
power and overheating. The following table shows the correct size to use depending on cord
length and nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller
the gauge number, the heavier the cord.
The label on your tool may include the following symbols.
Symbols
V ..........................volts
Hz ........................hertz
min ........................minutes
......................direct current
.......................... Class II Construction
........................safety alert symbol
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities contains chemicals known to the State of California to
cause cancer, birth defects or other reproductive harm. Some examples of these
• lead from lead-based paints,
chemicals are:
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling,
with soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin may
and other construction activities. Wear protective clothing and wash exposed areas
promote absorption of harmful chemicals.
serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved
WARNING: Use of this tool can generate and/or disburse dust, which may cause
respiratory protection appropriate for the dust exposure. Direct particles away from face
and body.
• ALWAYS USE PROPER EYE AND RESPIRATORY PROTECTION.
Safety Warnings and Instructions: Sanders
• Clean your tool out periodically.
Minimum Gauge for Cord Sets
Volts
120V 0-25
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
240V 0-50
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Ampere Rating
More Not more
Than Than
0 - 6 18
6 - 10 18
10 - 12 16
12 - 16 14
Total Length of Cord in Feet
26-50 51-100
51-100 101-200
American Wire Gage
16 16
16 14
16 14
12 Not Recommended
A..........................amperes
W ........................watts
n o ........................no load speed
.../min ..................revolutions or
4
101-150
201-300
14
12
12
......................alternating current
........................earthing terminal
reciprocations per minute