Safety Information - Zoeller 1332-0006 Manual De Instrucciones

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate, or install the
product.
• NOTE: Pumps with the "UL" Mark and pumps with the "US" mark are tested to UL Standard
UL778. CSA certified pumps are certified to CSA Standard C22.2 No. 108. (CUS)
DANGER
ELECTRICAL SHOCK HAZARD.
Always disconnect power source before performing any work on or near the motor or its connected load. If the
power disconnect point is out-of-sight, lock it in the open position and tag it to prevent unexpected application of
power. Failure to do so could result in fatal electrical shock.
ELECTRICAL SHOCK HAZARD.
Do not handle the pump with wet hands or when standing in water as fatal electrical shock could occur.
Disconnect main power before handling unit for ANY REASON!
RISK OF ELECTRIC SHOCK.
These pumps have not been investigated for use in swimming pool areas.
WARNING
ELECTRICAL SHOCK ALERT.
Follow all local electrical and safety codes, as well as the National Electrical Code (NEC) and the Occupational
Safety and Health Act (OSHA).
ELECTRICAL SHOCK ALERT.
Replace damaged or worn wiring cord immediately.
ELECTRICAL SHOCK ALERT.
Do not kink power cable and never allow the cable to come in contact with oil, grease, hot surfaces, or chemicals.
ELECTRICAL SHOCK ALERT.
Unit must be securely and adequately electrically grounded. This can be accomplished by wiring the unit to a
ground metal-clad raceway system or by using a separate ground wire connected to the bare metal of the motor
frame or other suitable means.
CHEMICAL ALERT.
Prop65 Warning for California residents:
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
CAUTION
ELECTRICAL SHOCK MAY OCCUR
Protect the power cable from coming in contact with sharp objects.
HOT SURFACE MAY CAUSE BURNS
Be careful when touching the exterior of an operating motor - It may be hot enough to be painful or cause injury.
PRODUCT DAMAGE MAY RESULT
Make certain that the power source conforms to the requirements of your equipment.
2