Repair Kit & Repairs - Jobe E-DUNA SUP Manual De Instrucciones

ERROR NOTIFICATION: A red LED will indicate anytime the Drive has detected an error.
- compressor overheating: red 1x
- motor overheating: red 2x
- LED overheating: red 3x
- battery overheating: red 4x
- motor jammed/blocked: red 5x
- system error: red continuously shines
Temperature errors reset themselves when the temperature subsides. An overloaded motor is reset - after the error is addressed
(such as cleaning the propeller) - by turning the Drive off and on again. System errors are corrected by unplugging and replugging
in the battery.
WARNING ONLY unplug the battery when on land in a dry environment.
If the system error remains, it MUST be sent to be serviced.
Contact your dealer or [email protected].
REPAIR KIT
All boards come with a repair kit in the event of small holes or punctures in the SUP itself. Instructions for repair are included in
the kit itself. If you have a hole larger than that which can be repaired with the included kit, it shall be considered that you were
improperly using the board and the warranty will not cover a repair. Depending on the size of the puncture, it might still be
repairable. If you are unsure as to whether a puncture is repairable, contact Jobe and we will advise you about the appropriate
steps.
REPAIRS
Propeller:
A spare propeller is included with the board. It may be replaced ONLY when the Drive's battery is not connected. (see picture)
Remove the protective mesh covering with the included tool, and either manually or with water clean the canal.
Hole in the SUP:
- Find the leak.
- Deflate the SUP
- Find or cut a suitable patch, preferably of round or oval shape.
- Thoroughly clean the area on the SUP, with rubbing alcohol if possible. The area MUST
be dry.
- Put the patch on the SUP and mark on the patch size and shape needed.
- Evenly apply sealant to the patch's outline on the SUP and on the back of the patch.
- Wait 5 to 10 minutes for the sealant to become tacky to the touch.
- Lightly press the patch on the area to be repaired, with the sealant sides touching.
Make sure there are no bubbles under the patch. Press with more force and flatten it
out strongly, using the back of a spoon or another hard, smooth object.
- Leave at least 24 hours to dry thoroughly
Repair kit & Repairs.
20