Kohler K-9655 Manual Del Usuario página 5

Mounting
Holes
Locations
Adhesive
Pad
2. Install the Lavatory
Locate and mark the bracket mounting hole locations on the wall.
Make sure the mounting holes are level and the drain is properly
aligned.
Drill a 1/4" (6 mm) hole in the center of each mounting hole
mark.
Install the grommets to the bracket mounting holes.
Apply six adhesive pads evenly along the top and bottom back
surface of the bracket.
Carefully position the bracket on the wall, aligning the bracket
mounting holes with the drilled holes. Secure the bracket to the
wall with washers and lag screws through the bracket holes.
CAUTION: Risk of product damage. Use extra care to avoid
scratching the lag screw finish when tightening.
CAUTION: Risk of product damage. Do not overtighten the lag
screws, as damage to the bracket may result.
Carefully tighten the lag screws to avoid scratching the finish. Do
not overtighten the screws.
Install the faucet to the wall according to the faucet
manufacturer's instructions.
Kohler Co.
Wall
Grommet
Washer
Lag
Screw
Silicone
Sealant
Bracket
5 1007276-2-B