Environmental Notice - Braun Flex XP II System Manual Del Usuario

Replacing the shaving parts
To maintain 100% shaving performance,
replace your foil and cutterblock every 18
months or when worn. Change both parts at
the same time for a closer shave with less skin
irritation.
Preserving the batteries
In order to maintain the optimum capacity of
the rechargeable batteries, once every six
months fully discharge the shaver by shaving.
During the time of discharging, clean only
manually and not in the Clean&Renew™. Then
recharge the shaver in the Clean&Renew™ to
full capacity again.
Accessories
Available at your dealer or Braun Service
Centers:
Shaver foil and cutter block
(part no. 5000/6000)

Environmental notice

This appliance is provided with
nickel-cadmium batteries. To
protect the environment, do not
dispose of this appliance in the
household waste at the end of its useful life.
Disposal can take place at a Braun Service
Center or appropriate collection sites.
B Clean&Renew™
Braun Clean&Renew™ has been developed
for cleaning, charging and storing your shaver.
Clean your shaver daily in the
Clean&Renew™.
During the automated cleaning process,
the shaver is switched on and off at intervals
to obtain best cleaning results. Since the
specially formulated cleaning fluid contains a
small amount of oil, the cleaning procedure
also fulfills the shaver's lubrication needs.
Important
• Only use the special cord set supplied with
the shaver.
• In order to avoid any leakage of the cleaning
fluid, place the appliance on a flat, stable
surface. Do not tip, move suddenly or
transport in any way if a cleaning cartridge
is installed.
• Do not place the appliance in a mirror cabi-
net, nor store it over radiators, nor place it
on polished or laquered surfaces. Do not
expose to direct sunlight.
• The appliance contains highly flam-
mable liquid. Keep it away from
sources of ignition. No smoking.
Keep out of reach of children. Do not refill
cartridge. Use only original Braun refill
cartridge.
• When cleaning the shaver, its protection
cap should be removed.
Description
1 Lift button for cartridge exchange
2 Contact bow
3 Start/release button
4 Level indicator
5 Cleaning cartridge
9