Westfalia 345040600001 Manual De Montaje página 2

SIARR
46 - 26
PREPARATION
* Remove the rear bumper.
* Make a cut in the bumper as per the sketch.
ASSEMBLY
* Locate the 6 holes marked W and Y under the vehicle.
* Position shims A under the vehicle, and use them to counter
drill hole X through the longitudinal (to be done at each side).
* Position the shims A inside the longitudinals
and slide the tow bar B into the longitudinals.
* Position the back plates D inside the boot, then
fasten the tow bar using fastening kits W, X and Y.
* Dismantle the bumper fastenings and remove them.
* Refit the bumper supports to Z using fastening kit Z.
FINISHING
* Tighten all of the nuts, bolts and screws to the torques indicated below.
* Replace the bumper.
FASTENING KIT
2 off HM16x45 screws
U
2 off HM16 nuts
2 off DEC16 washers
4 off HM12x35 screws
4 off 12/27 plain washers
V
4 off CS12 washers
4 off HM12 nuts
4 off HM10x90 screws
4 off HM10 nuts
W
4 off 10/27 plain washers
4 off CS10 washers
M16 AC8.8 19,5daNm M12
M16 AC10.9 27,5daNm M10
M12 AC8.8 8,1daNm M10
ASSEMBLY INSTRUCTIONS
160,0
4 off HM10x90 screws
X
4 off HM10 nuts
4 off CS10 washers
Y
8 off 10/27 plain washers
4 off HM8x25 screws
4 off HM8 nuts
Z
4 off CS8 washers
4 off 8/25 plain washers
TORQUES :
AC10.9 11,4daNm M8 AC8.8
AC8.8 4,7daNm M8 AC10.9
AC10.9 6,7daNm
FILE : BUREAU\NOTICEDEMONTAGE\SIARR\NDWESTFALIA\NDM4626-D - FOLIO NDMANG
D
Y
W
X
Z
Type Type
Approval No.
Tow bar for
KIA CARENS e11*94/20*00*4246
2002
NB : Electrical diagram inside our universal or custom wiring kits.
PLEASE NOTE : (to familiarise yourself with the operating charasteristics refer to the log)
2,3daNm If this tow bar is fitted in accordance with our recommendations it will give a complete-
3,3daNm ly satisfaction. We cannot accept any responsability in the event of changes to or
improper use of this item.
345040600001
!
Affix the sticker in the position
Y
X
A
B
V
C
Max. Total Max. Total Max. Verti-
cal load
Authori. Weight Towable Weight
1 975 kg 1 250 kg
W
Z
U
Value
D
75 kg 7,51 kN