HP q2440b Manual De Instalación página 5

CAUTION Do not fan the paper. Fanning can
cause misfeeds.
Load paper into the tray.
To take advantage of all the feeder
functions, the printer driver on the printer's
host computer must be configured to
recognize the feeder. For Windows
the printer Properties window. On the Device
Settings tab, select the check box for the 500-
sheet feeder.
Make sure that the paper is flat at all four
corners and that the top of the stack is below
the maximum-height indicators. Slide the
paper tray completely into the printer.
To verify that installation is complete, print a
configuration page from the control panel.
Press to open the printer menus. Press
® , go to
to select INFORMATION, and then press
. Press to select PRINT
CONFIGURATION, and then press
Connect the cables to the rear of the printer
(callout 1). Turn the printer power on (callout
2).
Note
were connected to the printer that are not
shown in this illustration. Make sure that you
connect
connected to the printer.
Make sure that the configuration page lists
the 500-sheet feeder as an installed
accessory. If the feeder is not listed on the
configuration page, see the use guide on the
CD-ROM that came with the printer.
.
5
There might be additional cables that
all of the cables that were previously
hp LaserJet
4250/4350 series
1