Brizo MultiChoice Virage T60030 Manual Del Propietário página 4

60 Series Installation
2
Showerhead and Tub Spout Installation
NOTE: It is suggested that you anchor your shower arm and tub spout
elbows or water lines.
3
A.
RP62605s
(3) = 3/8" - 1/2" (9.5 mm - 12.7 mm)
FOR TUB SPOUT INSTALLATION:
Install 1/2" (13 mm) threaded pipe nipple (1) to
extend past finished wall (2) per dimension (3).
Connection of deck mount spouts to in–wall
valves is not recommended. Neither is the use
of hand showers connected to tub spouts in a
tub/shower push button diverter combination, or
hand showers connected in lieu of a tub spout
to a tub / shower valve.
Piping between valve body and tub spout must
be a minimum of 1/2" (13 mm) copper pipe
or 1/2" (13 mm) iron pipe in a straight drop
no less than 8" (203 mm) but no more than
18" (457 mm) long with only one iron pipe or
copper 90 degree elbow to the tub spout nipple.
1
4
2
1
3
2
VIRAGE SHOWERHEAD AND SHOWER
®
ARM INSTALLATION:
pipe nipple to extend beyond the finished wall
3/8" to 1/2". Apply plumber tape to thread on pipe
nipple and screw brass adapter (1) securely onto
nipple. Apply plumber tape to outlet end of
shower arm and screw showerhead (2) onto the
shower arm (3), using provided wrench (4) to
tighten securely. Check position of set screw on
top of shower arm (3) making sure it is not
sticking through to the inside opening where it
could interfere with the assembly. Slide shower
arm and head assembly over the adapter and
tighten set screw against the adapter.
B.
3
Install a 1/2" threaded pipe nipple to extend
beyond the finished wall 3/8" to 1/2". Apply
plumber tape to thread on pipe nipple and screw
brass adapter (1) securely onto nipple. Check
position of set screw on bottom of spout (2)
making sure it is not sticking through to the
inside opening where it could interfere with the
assembly. Slide tub spout over the adapter and
tighten set screw, on bottom of spout, against
the adapter. Note: This spout utilizes a pull
down diverter mechanism. To divert from
spout to shower, pull down on spout tip (3).
4
Install a 1/2" threaded
2
1