How To Set Your Switch Cap Remote Receiver; How To Set Up Your Remote Control - Fanimation FP1280 Serie Manual De Instrucciones

How to Set Your Switch Cap Remote Receiver

This step is to be completed prior to hanging your motor.
1. Removing the Switch Housing:
Remove the switch housing from the motor by
unscrewing the three screws and unplugging the
connector (Figures 1 & 2).
2. Removing the Receiver Unit:
Carefully, slide the remote Receiver from the Switch Cap
Housing, and locate the code switches on the underside
of the receiver unit (Figure 3).
3. Setting the Receiver Code:
The remote unit has 16 different code combinations.
It may be necessary to test a couple frequency code
settings to improve signal reception and/or eliminate
interference from other remote control household items.
Multiple fans should have different code settings to allow
independent fan control. To set the code, slide code
switches to the same positions as is set on your TR20
transmitter (Figure 3).
4. Installing Receiver in Switch Cap Housing:
Slide remote Receiver into the Switch Cap, connect the
plug from the motor assembly into the socket located in
the receiver unit (Figure 2 & 3).
5. Installing the Switch Cap Housing:
Slide the assembled Switch Cap Housing over the Switch
Cap Base by installing and tightening the three screws
(Figure 1).
WARNING
Check to see that all connections are tight. To avoid
possible electrical shock, make sure that the electrical
wires are completely inside the switch housing and
not pinched between the switch cap base and switch
housing.
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.

How to Set Up Your Remote Control

ON ECE
Remote
Transmitter
Unit Detail
arrow and slide battery cover off. Slide code switches
to your choice of up or down position. Factory setting
is all up. Do not use this position. With a small
screwdriver or ball point pen slide firmly up or down
(Figure 1). Replace battery cover on the transmitter.
7
Figure 1
Figure 2
Figure 3
ON ECE
1 2 3 4
Figure 1