Troubleshooting Your Mr. Coffee ® Coffeemaker - Mr Coffee MR Serie Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING YOUR MR. COFFEE
Your MR. COFFEE
Coffeemaker has been carefully designed to give you many years of trouble-free service.
®
In the unlikely event that your new coffeemaker does not operate satisfactorily, please review the following
potential problems and try the steps recommended BEFORE you call an Authorized Sunbeam Service Center.
PROBLEM
THE "BREW NOW"
LIGHT DOES NOT LIGHT UP
THE COFFEE IS
NOT BREWING
THE COFFEEMAKER
ONLY BREWS WATER
THE COFFEEMAKER
BREWS SLOWLY
THE FILTER BASKET
OVERFLOWS
18
POSSIBLE CAUSE
• The appliance is unplugged.
• There's a power outage.
• The appliance is unplugged.
• There's a power outage.
• The water reservoir is empty.
• The filter basket is not
properly inserted.
• The decanter is not
placed all the way on
the warming plate.
• There are no coffee grounds
in the filter basket.
• The coffeemaker needs cleaning.
• The filter basket is not
properly inserted.
• The decanter is not
placed all the way on
the warming plate.
• The decanter lid is
not on decanter.
• Too many coffee grounds
were placed in the filter.
• The decanter was removed from
the warming plate for more than
30 seconds.
• Too much or too fine decaffienated
ground coffee was placed
in the filter.
COFFEEMAKER
®
SOLUTION
• PLUG UNIT IN.
• WAIT FOR POWER TO
BE RESTORED.
• PLUG UNIT IN.
• WAIT FOR POWER TO
BE RESTORED.
• CHECK THE WATER
WINDOW.
• INSERT FILTER BASKET
CORRECTLY.
• PLACE DECANTER
CORRECTLY ON
WARMING PLATE.
• ADD THE DESIRED
AMOUNT OF COFFEE
TO THE FILTER.
• CLEAN COFFEEMAKER
AS DESCRIBED IN
"CLEANING AND
MAINTAINING" SECTION.
• INSERT FILTER BASKET
CORRECTLY.
• PLACE DECANTER
CORRECTLY ON
WARMING PLATE.
• PLACE LID ON THE
DECANTER.
• REMOVE FILTER AND
DISCARD GROUNDS.
IF PAPER FILTER, REPLACE. IF
PERMANENT FILTER, RINSE.
BEGIN BREWING PROCESS
AGAIN.
• TURN OFF AND UNPLUG
THE UNIT. ALLOW TO
COOL. WIPE UP THE
SPILL. DO NOT SET HOT
DECANTER BACK ON THE
WET WARMING PLATE OR
IT MIGHT CRACK.
• Set "Brew Strength"
selector to STRONG to
slow brew cycle down.

Capítulos

Tabla de contenido
loading

Tabla de contenido