Install The Neck Jet Pillow; Test Run The Whirlpool - Kohler K-1332 Guia De Instalacion

Fit the slip cover
over the pillow

8. Install the Neck Jet Pillow

- The whirlpool is supplied with one pillow and two slip covers. The pillow includes a built in magnetic reed
switch. The neck jets will not operate unless the pillow is installed. Always use a slip cover to prevent water from
spraying from the whirlpool.
- Choose a slip cover, and fit it over the pillow.
- Carefully slide the pillow down onto the neck jet body grooves until it is secure. The neck jets are now ready for
use.
- We recommend periodic cleaning of the slip cover. Follow the cleaning instructions on the label attached to the
slip cover.

9. Test Run the Whirlpool

- Check all electrical connections, and make sure the electrical power to the whirlpool is turned on.
- Make sure all union connections to the pump are securely hand tightened.
- Verify that the pump banding straps have been cut, and that the pump base is resting directly on the subfloor.
- Fill the whirlpool to a level above the water level sensors located near either one of the grip rails or the back jets.
The whirlpool will not operate unless these sensors are completely covered with water.
- Operate the whirlpool for 5 minutes, and check all whirlpool piping connections for leaks.
- Turn on the neck jet and back jet features. Check for any water leakage on the whirlpool's back side.
- For additional information on whirlpool operation, see Confirm Proper Operation on Page 10.
B
1012425-2-
Slide the pillow onto
the neck jet body
8
Neck Jet Body
Kohler Co.