Cleaning; Troubleshooting/Tip; Tip - Britax DUALFIT Guia Del Usuario

BRITAX Child Safety, Inc.

Cleaning

Shell • SPONGE CLEAN
the shell using warm
water and mild soap�
• TOWEL DRY
Cover • HAND WASH the
cover using cold
water and mild soap�
• LINE DRY to prevent
the cover from
shrinking�
Harness • SPONGE CLEAN the
harness using warm
water and mild soap�
• TOWEL DRY
Harness • THOROUGHLY
Buckle RINSE the buckle
using warm water�
• TEST THE BUCKLE
by fastening and
unfastening until a
click is heard after
inserting each buckle
tongue� If clicks are
not heard, repeat the
cleaning procedure�
• TOWEL DRY
42
DO NOT
• Use abrasive
cleaners�
DO NOT
• Bleach
• Machine wash
• Machine dry
• Iron
DO NOT
• Disassemble the
harness
• Bleach
• Machine wash
• Machine dry
• Iron
DO NOT
• Soak
• Lubricate
• Use solvents
• Use soap or
household
detergents

Troubleshooting/Tip

Problem
The harness is Check that the harness and/or
hard to adjust�
adjuster straps are not twisted and
that they are threaded properly�
Check that the harness height is
properly positioned, at or above the
shoulders of the child� See page 22�
Pull adjuster strap away from child
seat (parallel to ground) to tighten�
Do not pull sideways�
The vehicle seat may be interfering
with installation� See page 22�
The adjuster Pull the harness adjuster strap
strap is fraying
away from the child seat (parallel to
at the sides�
the ground) to tighten� Do not pull
sideways� Doing so may cause the
harness adjuster strap to fray at the
sides�
The buckle will There may be debris in the buckle
not fasten with
mechanism� Clean the buckle as
a click after
shown on page 43 and try fastening
each tongue is
the buckle again�
inserted�
Please contact Britax Consumer Services at 1-888-427-
4829 or 1-704-409-1699 if you have an issue not listed
here.

Tip

Ensure proper installation of the
child seat by routing the lap and
shoulder portions of the vehicle
seat belt through the gap/notch in
the seat shell as shown�
DUALFIT User Guide
Possible Solution
43