Installation Steps; Care And Cleaning - LUND Ventvisor Elite Instrucciones De Instalación

Installation Steps

Insert visor into window channel, rear flange first. Rear
flange inserts between the rubber and frame. The front &
top flange slides into the window channel.
NOTE: It may be necessary
to pull the window channel out at the rear to seat the
rear flange.
3
With the visor in its final position, remove the remain-
der of the tape liner by pulling on free ends.
5
Continue to apply pressure to ensure that the visor
remains properly seated inside the window channel
as window is slowly closed. Leave window up for 72
hours to secure visor to window channel.
72
50°F / 10°C Min.
6 7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Lund ® branded products offered by Lund International, Inc. We take the utmost pride in
our products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product
is top quality in terms of fit, durability, finish and ease of installation.
™
NOTE: Actual application may vary slightly from illustrations.
Lund International
800-241-7219 • Visit us at lundinternational.com
© 2015 Lund International, Inc. All rights reserved.
Lund and the Lund logo are trademarks of Lund International, Inc.
® ®
Press the exposed area of tape against the surface and
4
Apply pressure along the inside of window channel and
flange edges to secure in place.
6
4 Piece Set
preparation and installation methods as the front visor.
Note that front flange fits between the rubber and frame,
and the rear flange attaches to the window post.
8
Repeat steps 1 thru 8 for passenger side
Page 2 of 2
verify position.
Install the rear visors using the same