Installation Steps - LUND Ventvisor Elite Instrucciones De Instalación

Installation Steps

Roll down window. Buff the inside felt surface
with scotch brite pad. Then clean with alcohol
clean
1
NOTE: visors mount on the inside of the window
Slide the front end flange of the visor inside window
channel. Then slide top and rear end flanges into posi-
tion inside channel.
3
With visor in final position, remove remaining tape liner
by pulling on free ends.
5
Continue to apply pressure to ensure that the visor
remains properly seated inside the window channel
as window is slowly closed. Leave window up for 72
hours to secure visor to window channel.
72
50°F / 10°C Min.
7
NOTE: Actual application may vary slightly from illustrations.
pad.
inside of vehicle
channel.
top flange
free end
2
Press the exposed area of tape against the surface and
4
Run your finger along inside of window channel to en-
sure proper adhesion of taped flange to felt surface. Roll
6
4 Piece Set
8
Page 2 of 3
free end
front
flange
flange
verify position.
window up.
If applicable, rear visor attached
directly to painted surface.
Pop out visor installed
Repeat for opposite side.
rear