Installation Steps; Care And Cleaning - LUND Ventvisor Deflector Instrucciones De Instalación

Installation Steps

Insert visor into window channel, front flange first.
3
NOTE: It is necessary to both hold the visor up into the
window channel AND pull the bottom of the visor slightly
outward while raising the glass to seat visor properly.
5
4 Piece Set
Install the rear visors using the same preparation and
installation methods as the front visor.
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Lund ® branded products offered by Lund International, Inc. We take the utmost pride in
our products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product
is top quality in terms of fit, durability, finish and ease of installation.
™
NOTE: Actual application may vary slightly from illustrations.
Lund International
800-241-7219 • Visit us at lundinternational.com
© 2015 Lund International, Inc. All rights reserved.
Lund and the Lund logo are trademarks of Lund International, Inc.
® ®
Apply pressure to all flange edges to ensure proper
adhesion. Remove tape liner by pulling on free ends.
4
Continue to apply pressure to ensure that the visor
remains properly seated inside the window channel
as window is slowly closed. Leave window up for 72
hours to secure visor to window channel.
72
50°F / 10°C Min.
6
If the visor does not seat correctly, roll down
NOTE: It is necessary to both hold the visor up into the
window channel AND pull the bottom of the visor slightly
outward while raising the glass to seat visor properly.
If the visor does not seat correctly, roll down
8
Repeat Steps 1 thru 8 for passenger side.
Page 2 of 2
window and repeat Step 5.
window and repeat Step 8.