Ibx S50L Manual De Usuario página 8

compressor
uP-
Start threshold
Compressor
dn- Closing the
threshold
Floodlight
Lt-
time
Sterilization lamp
St-
time
Pb- Zero adjustment
Full degree
adjustment
PK-
INDICATOR NAME
Lc Password
Power down
rES
memory function
FAn Fan Type selection
Maximum power
nP-
output
When the compressor is working intermittently, IF
temperature temperature
≥
measurement set value
AND the compressor start delay time is up, THEN
the compressor starts working.
Note: This parameter is valid only in the manual
start/stop mode.
When the compressor is working in the
intermittent mode, IF
temperature temperature
≤
measurement
THEN, the compressor turns OFF.
Note: This parameter is valid only in the manual
start/stop mode.
Time the floodlight stays ON every time.
When Lt=0, the delay is invalid and the lights
need to be turned off manually.
Time the sterilization lamp stays ON every time.
When St=0, the delay is invalid and the lights
need to be turned off manually.
Correction of errors caused by sensor low
temperature measurement.
actual
Pb =
temperature
value
Correction of errors caused by sensor high
temperature values.
actual temperature
value
×
= 1000
PK
temperature measured value
FUNCTION DESCRIPTION
The password to modify the parameters in this
table is Lc = 9
0: OFF – if the power goes off, the controller
will stop working.
1: ON – if the power goes off, when the device
is turned on again it will continue running the
functions it was running when the power went
off.
0: The fan is a short axis fan.
1: Fan is a long shaft fan.
The maximum power percentage of the heating
output.
+ uP
+ dn
set value
temperature
_
measured
value
temperature
-
measured value
8
(-10.0～10.0℃)
0.4
(-10.0～(uP-0.1))
0.2
(0～9999min)
0
(0～9999min)
0
(-99.9～99.9℃)
0
(-999～999) 0
FACTORY VALUE
0
(0～1)
0
(0～1)
0
(0～100%)
100