RedMax BTR250PL Manual De Taller página 10

5. Dismantle the battery housing. See
the battery housing on page 14 .
6. Disconnect the wires (A, grey), (B, black) and (C,
red) from the control unit.
A
B
C
7. Loosen the screw and lift off the motor while pulling
the cables out of the shaft.
10 - Repair instructions
To disassemble
5.10.2 To assemble the motor
1. Pull the wires through the shaft. Fasten the wires to
2. Fasten the motor to the shaft.
3. Connect the wires to the control unit with (A, grey) at
4. Assemble the battery housing. See
5. Assemble the wear guard under the battery housing.
6. Assemble the operating handle. See
a steel wire to make this easier.
the top, followed by (B, black) in the middle and (C,
red) at the bottom.
A
B
C
battery housing on page 14
To disassemble and assemble the battery
See
housing wear guard on page 13
the operating handle on page 14
To assemble the
To assemble
572 - 001 - 28.03.2018