Idiomas disponibles
Idiomas disponibles
Facts about blades and oiling:
• Blades not only become dull from cutting hair – they are dulled by the abrasive particles on the hair, dirt, sand etc.
• Blades will not cut if abrasive particles are picked up and carried between the blades. These particles tend to hold the blades apart and cause
chewing and pulling instead of clean cutting.
• Oiling the blades performs two distinct functions:
1) Provides a low friction, very thin lubricant film between the cutting blades so that they can take a full cutting stroke without becoming hot from friction.
2) Flushes abrasive particles and hair out from between the blades.
Note: If you cut into dirt, immediately wash with oil to flush out.
• Before cleaning/maintenance, switch the equipment off and remove the main plug from the socket.
• Never immerse the unit in water.
• Each time after use remove any hairs from the cutting blade using the cleaning brush.
• Clean the body of the clipper with a soft, damp cloth. Never use solvents or scouring agents.
• The cutting head should be cleaned and oiled frequently with Wahl Clipper Oil in order to maintain its good cutting performance and thus ensure a
long service life.
• The cutting head should be replaced if the cutting performance is reduced after extended use despite regular cleaning and lubrication.
• During use always be sure the cord is not twisted or running over any sharp objects that might cut the cord insulation.
:
Directions
1) Turn unit on/ off
Variable Speed:
• Turn variable speed switch in clockwise direction to turn unit on and increase speed. To turn unit off and reduce speed, turn switch counter
clockwise until hearing a click. (fig. 1)
Two Speed Toggle:
• Flip toggle switch up or down to desired speed. To turn unit off flip toggle switch to center position. (fig. 2)
Two Speed Switch:
• To slide switch into any position first press down on locking button in the middle of the switch and then slide. (fig. 3) Slide switch down for desired
low or high speed. (fig.4) To turn unit off flip toggle switch all the way up
2) Remove/ replace blade
• The clipper should be switched off before removing blades.Remove blade. (fig. 5) The cutting head can be removed by pressing the button under
the blade and pushing the blade away from the housing. Note: Blade button not available on all models. To refit the blade set, the clipper should
be turned on and running. Fit the blade into the metal guide and press it into place. There will be a definite "click" when the blade is snapped in
place.
3) Remove/ replace drive tip
• See step 2, then remove drive tip by grasping with drive tip removal tool and pulling. (fig. 6A) Install by aligning lower end of drivefinger and
pushing until drive tip snaps into position. (fig. 6B) (Don't use pliers to replace tip, as this may damage the part.)
4) Remove/ replace hinge
• See step 2, then remove two screws. Lift hinge assembly from unit. (fig. 7)
FIG.1
on
low
high
FIG.5
PRECAUCIONES IMPORTANTES
Cuando esté usando un aparato eléctrico, han de tomarse unas precauciones básicas incluidas las siguientes: Lea estas instrucciones antes de
usar este aparato.
ADVERTENCIA:
1)No intente recoger un aparato eléctrico que se haya caído al agua. Desenchúfelo inmediatamente.
USE WAHL CLIPPER OIL ONLY.
Cleaning and general care
FIG.2
FIG.6B
FIG.6A
Para reducir el riesgo de muerte o daños por electrocución:
FIG.3
FIG.4
FIG.7
