Installing The Blower Belt, Spring, And Blower-Belt Cover - Toro Z Master 4000 Manual Del Operador

3. Move the latch pin from the locking position to
the open position
Figure 28
1. Blower assembly
2. Latch pin (locking position) 6. Idler pulley
3. Latch pin (open position)
4. Chute bracket
4. Close the blower assembly and align the latch
pin with the hole in the chute bracket
5. Move the latch pin to the locking position.
Note:
Ensure that the latch pin extends through
the hole in the chute bracket.
Note:
Ensure that the latch firmly holds the
blower assembly against the mower deck, but
you can release it by hand.
(Figure 28).
5. Idler-pivot bracket
7. Belt (beneath the idler
pulley)
(Figure
13
Installing the Blower Belt,
Spring, and Blower-Belt
Cover
Parts needed for this procedure:
1 Blower-belt cover
1 Cover knob
Procedure
1. Arrange the blower belt around the drive pulley
as shown in
g018370
28).
1. Blower pulley
2. Idler/pulley
3. Blower belt
2. Temporarily route the belt beneath the idler
pulley (Figure
20
Figure 29.
Figure 29
4. Drive pulley
5. Idler/tension pulley
30).
g341600