Tips And Advice On Installation; Use And Maintenance; Use From The Appliction; Controlling Up, Down, My - SOMFY Sonesse 30 ZIGBEE Li-ion Manual

Sonesse 30 WF Zigbee Li-Ion

2.4. TIPS AND ADVICE ON INSTALLATION

2.4.1. Questions about the drive?
Observations
Drive battery is low and requires
charge. Red LED blinks 3 times
when any button of a paired
control point is pressed.
The control point battery is low.
The driven product
The control point is not compatible
does not operate.
or not programmed.
Drive position is out of the end
limits.
The motor is not linked to a
network.
The thermal protection has
activated.
The end limits are incorrectly set
The driven product has exceeded
The driven product recommended weight limit.
stops too soon.
Battery is low. Red LED blinks 3
times when any button of a paired
control point is pressed.
The red LED of the There is a setting error.
remote control
lights up.
2.4.2. Erasing the memory of the motor (factory default)
͉
͉
This reset deletes all remote control, all the settings, the network, and resets the motor's favorite
position .
Press and hold the motor head programming button (≈ 12 s) until the product makes 3 back and forth
movements (the first feedback after 2 s, the second after 7 s and the third after 12 s).

3. USE AND MAINTENANCE

3.1. USE FROM THE APPLICATION
The motor control and tilting control are possible from the application: follow the instructions on
the Somfy Smart Setting application.

3.2. CONTROLLING UP, DOWN, MY

1) To move the driven product from a limit to the other limit, briefly press the UP or DOWN button.
2) To stop the driven product, briefly press the MY button.
3) If a my position is recorded) To move the driven product to the my position, briefly press the MY
button.
Copyright 2017 - 2019 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
Possible causes
CONTROLLING UP, DOWN, MY: IN ROLLER MODE
Solutions
Plug in the charger.
Check the battery and replace it as
required.
Check the compatibility and replace
the remote control if necessary.
Proceed to section «Setting the end
limits»
Go to chapter Network management
Wait for the drive to cool down.
Reset the end limits.
Replace driven product.
Charge the battery.
Go to chapter Drive settings
EN
5