RIB KIT JACK 30 SS Manual Del Usuario página 34

G
B
10.3 ADDITION OF OTHER RADIO CONTROLS
1. Press and hold down for 5 seconds the STOP key of the transmitter (already stored in the memory); the motor moves for 1 second in both directions.
2. Press the RISE key within 5 seconds, and press the DESCENT. Key within the next 5 seconds; the motor moves in both directions for 1 second.
3. Press the RISE push-button of the NEW transmitter within 5 seconds. If the new transmitter was correctly memory-stored, the motor moves in both directions
for 1 second.
4. If the memory storage was not successfully performed, repeat the procedure.
Up to 32 transmitters can be memory-stored in every receiver. If all the receiver's memories are occupied, the motor moves twice in both directions.
10.4 DELETION OF INTERNAL RECEIVER MEMORY (RESET)
1. Cut power to the motor.
2. Connect the black wire to the brown wire (If you have the step-by-step push-button, just hold it down without making any connection.
3. Power up the motor.
4. After 5 seconds, the motor moves in both directions for 1 second, signalling that the memory was completely deleted
5. Cut power to the motor again.
6. Disconnect the black and brown wire (Release the push-button if you have the step-by-step push-button).
10.5 TRANSMITTER TECHNICAL DATA
Power supply
Current consumption
Frequency
Modulation
Operating temperature
Range
Dimensions
Weight
1x 3V Battery, CR2032
10 mA
868,30 MHz
FSK
-20°C / +55°C
free-field: approx. 100 m
buildings: approx. 30 m
110 x 38 x 14 mm (without mounting plate)
37 g (incl. battery, without mounting plate)
34