RIB KIT JACK 30 SS Manual Del Usuario página 28

G
B
3.3 LT WIDTH BETWEEN 131 and 175 cm
For assemblies with an LT (Fig. 3-5) length between 175 cm (maximum) and 131 cm (minimum), use the motor and cap sleeves (Fig. 1 ref. 1 - 2) and the fixed
roller (Fig. 1 ref. 3).
To obtain the minimum value, fully insert the 2 sleeves (Fig. 10 ref. A-C) inside the fixed roller (fig. 10 ref. B) (Roller length 126 cm)
To obtain the maximum value, withdraw the 2 sleeves (Fig. 10 ref. A-C) from the roller, up to the safety limit marked on the plate (Fig. 10 ref. D) (Roller length 170 cm).
63
SLIDING
Motor sleeve (A)
WHEN YOU SLIDE THE SLEEVES TOWARD THE OUTER ENDS OF THE FIXED ROLLER, NEVER GO BEYOND THE SAFETY LIMITS (Fig. 10 ref.
D)
4
According to the type of assembly previously carried out on the electro-roller, as described in chapter 3, follow the instructions in the paragraphs below.
IMPORTANT: USE A RUBBER HAMMER TO INSTALL THE CAP (Fig. 11-12).
4.1 ASSEMBLIES DESCRIBED IN CHAPTERS 3.1 AND 3.2 (Fig. 8-9)
The cap (Fig. 1 ref. 5) must be installed directly on the fixed roller (Fig. 1 ref. 3). See figure 11
4.2 ASSEMBLIES DESCRIBED IN CHAPTERS 3.3 (Fig. 10)
The cap (Fig. 1 ref. 5) must be installed directly on the cap sleeve (Fig. 1 ref. 2). See figure 12
126 MIN
75
170 MAX
Fixed roller (B)
Safety limit (D)
INSTALLING THE CAP
28
63
SLIDING
Cap sleeve (C)
Fig. 10
Fig. 11
Fig. 12