Important - RIB KIT JACK 30 SS Manual Del Usuario

G
B
Motor support (A)
7
WARNINGS: 1) Before attempting any action on the system, cut out the electrical power supply.
2) Install an omnipolar switch on the power supply line for the automated system, with contact opening distance of 3 mm
1. Connect the wires of the electro-roller to the double button with mechanical interlock as shown in the lay-out of figure 17
2. Connect the double button with mechanical interlock to the power supply line as shown in Fig. 17.
3. Power up the electro-roller.
4. Press the rise push-button and check if the roller rotates in the winding direction.
5. If the rotation direction is incorrect, cut power and - in the double button with mechanical interlock (Fig. 17 ref. A) - change over the black wire with the brown
wire and check if operation is correct.
Press the descent push-button until the motor stops (BY DOING THIS OPERATION, WE HAVE ALREADY ADJUSTED THE CLOSING TRAVEL-LIMIT SENSOR.
6.
SEE CHAP. 9)
8
To secure the roller shutter to the electro-roller, use the belts (Fig. 1 ref. 7), the belt restraint clips (Fig. 1 ref. 9) and, if necessary, the hooks for the roller (Fig. 1 ref. 8).
IMPORTANT: Never use screws to install the belts - the motor inside the roller could be damaged.
1. Route the belt through the opening in the roller shutter (Fig. 18 ref. A).
2. Loosen the screw which fastens the plate (Fig. 16 ref. D).
3. Route the belt first under and then above the roller plate. (Fig. 18 ref. A-B).
Fit the clips and adjust the length of the belt so that it is slightly tightened. (Fig. 18 ref. B-C).
4.
Tighten the belt restraint clips with a pair of pliers (Fig. 18 ref. C).
5.
6. Tighten the screw on the plate you had loosened.
7. Check if the securing of the electro-roller/roller shutter complex is correct and firm.
Limit switch adjustment screws (B)
or more.
PHASE
NEUTRAL
BLUE
A
BROWN
BLACK
SECURING THE ROLLER SHUTTER TO THE ELECTRO-ROLLER
Guide holes on the plates (D)
ELECTRICAL CONNECTIONS
YELLOW - GREEN
30
Cap support (C)
Fig. 16
Fig. 17