Samsung RF34H9960S4 Manual Del Usuario página 16

6. Attach the front of the Top Cover, and then
press down on its back until it lies fl at. Re-
attach the screws.
• Assemble the Fridge and Freezer doors
in the reverse order of disassembly.
CAUTION
• If the Wire Connectors are cross-assembled,
the display will not work properly.
• Clips are located inside the cap on the top.
• To prevent water leaks, if the refrigerator uses
red clips, make sure the red clips are properly
connected to the Coupler after you insert the
Water Tube [E] into the center of the Coupler.
E E
• Keep the clips out of the reach of
children and make sure that children do
CAUTION
not play with them or put them into their
mouths.
DA68-03013A-05.indb 16 DA68-03013A-05.indb 16
Center of the Center of the
clip A clip A
(6.35 mm) (6.35 mm) Indicator Line Indicator Line
English - 16
LEVELING THE REFRIGERATOR
AND ADJUSTING THE DOOR
HEIGHT AND THE GAP BETWEEN
THE DOORS
HOW TO LEVEL THE REFRIGERATOR
If the Refrigerator is not level, it can cause a height
difference between the doors.
• Insert a Flat-Head (-) Screwdriver into the slot in
the Leveling Leg Control Lever and adjust the
level by turning the Control Lever clockwise or
counter-clockwise. When you rotate the Lever
clockwise, you raise the refrigerator. When you
rotate the Lever counter-clockwise, you lower
the refrigerator.
fl at-blade fl at-blade Control Lever Control Lever
screwdriver(-) screwdriver(-)
• If the Refrigerator is not level back and
front, put a solid panel (such as a plastic
panel, a plastic ruler, etc.) on the fl oor
where the rear legs will rest, and then fi x
it in place with plastic tape. When you
push in the Refrigerator, make sure the
rear legs rest on the panel.
• If you have a wooden fl oor or similar soft fl oor,
take care not to damage the fl oor when pushing
the Refrigerator into place.
2014. 5. 28. 2014. 5. 28. 10:08 10:08