What To Do When; Suitable Ir Remote Controls - Gira 0588 Serie Instrucciones Para El Uso

What to do when...

... equipment to be controlled does not re-
spond?
• Slide switch in position 'ON'?
• Instabus / IR converter in sight contact
with equipment to be controlled?
• Check the batteries of the remote control
for condition.
• Is the IR key concerned still programmed?
Repeat programming in acc. with
chapter "Programming the remote con-
trol".
• Has the IR memory been deleted
(chapter "Deleting the IR memory")?
Repeat programming in acc. with
chapter "Programming the remote con-
trol".
• IR window flashing green?
Check the position of the slide switch and
move to position 'ON'.
• IR window shining red?
The internal energy source is exhausted
and needs recharging. Wait a few minu-
tes until the red light goes out. If this is
not the case, contact the EIB installation
fitter.
... the remote control cannot be program-
med?
• Check that the remote control can be
used in combination with the Instabus / IR
converter (see chapter "Suitable IR remo-
te controls").
• Check the batteries in your remote control
for condition.
... further EIB appliances – e.g. pushbut-
tons, luminaires, blinds/shutters, etc. – are
to be used in combination with the Insta-
bus / IR converter ?
• The Instabus / IR converter must be repro-
grammed. Contact the EIB installation fit-
ter.

Suitable IR remote controls

The remote controls mentioned below can
be used in combination with the Instabus /
IR converter .
For detailed information, read the Technical
Data of your IR remote control (part of the
operating instructions of the remote control
or of the equipment to be controlled).
The remote controls or the electrical equip-
ment to be used with the Instabus / IR con-
verter must fulfill the following require-
ments:
• Infrared remote controls using the RC5
code.
• IR wavelength:
• Carrier frequency: 20...70 kHz and
455 kHz (Bang & Olufsen)
The following devices cannot be used:
• Remote controls without carrier frequen-
cy of older design
• Radio remote controls and transmitters
• The old Gira IR system cannot be used eit-
her.
920...970 nm
13