Remove the garment from the nylon balloon and hanger (1).
Pull the mains plug out of the plug socket and allow the device to cool down completely.
MAINTENANCE AND CLEANING
Unplug the mains plug out of the plug socket and allow the device to cool down com- pletely before
doing any cleaning!
Never immerse the device, the mains cable or the mains plug in water or other liquids!
Do not use any corrosive or abrasive cleaning agents or cleaning pads to clean the device. These can
damage the surface.
Clean the device and the nylon balloon if necessary with a slightly damp cloth and a little mild detergent
if required. Then wipe down fully with a dry cloth.
Allow all parts to dry completely before you put them away.
Store the device in a clean, dry place that is protected from sunlight and is not acces- sible to children
and animals.
Troubleshooting Guide
PROBLEM
POSSIBLE CAUSE
• Is the mains plug inserted in the plug socket correctly? Correct the fit of
The device does
the mains plug.
not work. The LEDs
• Is the plug socket defective? Try another plug socket.
do not light up.
• Check the fuse of the mains connection.
• Is the device switched on? Set the timer (6) to a time.
• Are the ventilation slots (5) covered up or blocked? Free up the ventilation
Unusual noises
slots (5).
• Are the ventilation slots (5) covered up or blocked? Free up the ventilation
slots (5).
• The device has an automatic safety switch-off function. It switches off
automatically if it overheats. Allow the device to cool down and switch it on
The device
again.
switches off
• Has the device fallen over? The device has a protective switch that is
suddenly.
activated if the device falls over. Set the de- vice up again and switch it back
on.
• Has the set time elapsed? Set the timer (6) to the time you want again.
• You might notice a slight odour caused by production res- idues the first
Odour produced
time you use the device. However, this is harmless and will cease as you use
the device.
15